The selection of asphalt shingles to meet the 2010 Florida Building Code, Residential (FBC-R) requirements for wind

resistance relies on three separate sets of standards, integrated into the building code and captured in asphalt shingle selection table R905.2.6.1 (below). The 2010 FBC-R requires that shingles be tested to product standards ASTM D7158 or D3161, and contains new wind design requirements that rely on a recently updated reference standard, ASCE 7. Developed and maintained by The American Society of Civil Engineers (ASCE), ASCE 7-10 provides building designers with detailed engineering criteria for the application of loads on structures.

For asphalt shingles, the code also relies on the ASTM product standards to help define the resistance of asphalt shingles to wind uplift forces. Additionally, the FBC-R includes detailed underlayment and fastening requirements for asphalt shingles. The end result is the proper selection and installation of an asphalt shingle that meets the test standards for the particular wind region.

ASCE 7-10

The ASCE 7 standard describes wind load requirements using wind maps that establish regional design conditions based upon measured, historical wind events. The wind maps in ASCE 7 provide design wind speeds for specific wind durations and a likely frequency. While previous versions of ASCE 7 contained a single wind map that established design wind speeds for 3-second gusts and a 50 year mean recurrence interval, the standard was revised to re-define the reference wind speeds in the maps. In an effort to simplify the design process, the new standard contains three separate maps that define “ultimate wind speeds” for differing building risk categories and varying return periods.

Because the FBC-R applies only to certain residential structures including one and two family dwellings, the code contains a single map.

Note: It is important to note that the wind speeds did not change significantly; rather it is the method of expressing the

design wind speeds that changed. Again, these changes were made only to simplify the calculations, not increase the

required level of shingle wind resistance.

The 2010 FBC-R Code and Shingle Selection

Follow the steps below to select asphalt shingles:

  1. Refer to the map in Figure R301.2(4) to determine the design wind speed for the specific project.
  2. Review the values for Maximum Basic Wind Speed in Table R905.2.6.1 to determine the lowest value that equals or exceeds the design wind speed in step 1 above.
  3. Select a shingle with a classification from either ASTM D 7158 or D 3161 that corresponds to the Maximum Basic Wind Speed determined in step 2 above.

DISCLAIMER OF LIABILITY: This document was prepared by the Asphalt Roofing Manufacturers Association and is disseminated for informational purposes only. Nothing contained herein is intended to revoke or change the requirements or specifications of the individual roofing material manufacturers or local, state and federal building officials that have jurisdiction in your area. Any question, or inquiry, as to the requirements or specifications of a manufacturer, should be directed to the roofing manufacturer concerned. THE USER IS RESPONSIBLE FOR ASSURING COMPLIANCE WITH ALL APPLICABLE LAWS AND REGULATIONS.

Nothing contained herein shall be interpreted as a warranty by ARMA, either express or implied, including but not limited to the implied warranties of merchantability, fitness for a particular purpose or non-infringement. IN NO EVENT SHALL ARMA BE LIABLE FOR ANY DAMAGES WHATSOEVER, including special, indirect, consequential or incidental damages or damages for loss of profits, revenue, use or data, whether claimed in contract, tort or otherwise. Where exclusion of implied warranties is not allowed, ARMA’s liability shall be limited to the minimum scope and period permitted by law.